1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 78Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 78

Fuel Pump Testing65 RS Before replacing suspect fuel pump, remove and clean the fuel filter and install new filter elementAlso
andcenter post or To loosen remove cover Do not lose small a-ring around large a-ring from outer edge of cover Wash filter
element with clean solvent and brush Install filter with lip facing toward fuel pump body Make sure the large a-ring is seated
in its groove in the cover and the small a-ring is in place around center post Install coverPosition inlet nipple between
screw heads Tighten the cover screw securelyFunctional Test Conduct this test with the motor in test tank or on the boatBefore
testing, loosen fuel tank gas cap momentarily to release any pressure that may have built upFuel tank must not be more than
30 in(76 cm) below fuel pump1Remove carburetor to fuel pump hoseConnect fuel pressure gauge between the carburetor and fuel