1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 81Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 81

Inspection r;l 1Inspect brass plunger shaft for any burrs or scratchesRemove small scratches by polishing the plunger with
and the primer pump housing must be replaced29281 housing and the syringePlace your thumb over end of the plunger housingSqueeze
the syringe to fill the plunger housingAlcohol should flow freely out of the small nipple, indicating no obstructionsIf no
flow is indicated, replace primer pump housingAssembly 161 5Install hose between the large nipple of the primer pump 01Position
the spring and washer on the plunger shaft1sl 2Install two new a-rings and quad-ring plunger 19l 3Install new a-ring onto
the end cap and position the end cap on the plunger shaftf101 4Insert plunger shaft and end cap into primer pump housingReinstall
retainer clipfive-inch piece of hose to the large nipple and place the other end of hose in container of alcoholPlace hose
on the small nipple and place other end of hose to drain into containerHold primer pump in horizontal position as it would