1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 88Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 88

Carburetor Body 1Check all drillings and passages with syringe filled with isopropyl alcohol2Visually inspect all gasket
circuit with isopropyl alcohol Check for leaks at point If leak occurs, blow dry and apply drop of OMC Ultra Lock at poi
nt Assembly Before proceeding, be sure that all parts are perfectly cleanBe sure that all replacement parts match original
ones in size and shapeReplace all gaskets, O-rings, and sealing washers each time you assemble carburetor r:;-:;l 1Install
new core plug with the convex side upSeat the plug using flat end punch and plastic malletApply Gasoila sealer, OMC PIN 200763,