1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 115Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 115

Power Pack Removal 1Separate the power pack connector(s)Twist and remove the primary lead covers from the ignition coils
indicatedInstall the screws and tighten to torque 3Apply isopropyl alcohol to the Ampheno connectorsAlign flat areas and
carefully plug togetherSecure with wire retainer where used 4Apply light coating of OMC Tripe-Guard grease to the opening
of each primary lead cover and install the coversObserve proper wire routing and ignition timingrefer to Ignition Coil Installation