1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 120Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 120

Function TestsS.L.DWThis ignition system incorporates the 5.L.0WTM warning system, which gradually limits engine speed to
engine in test tank and run at 3500 RPM 3Attach the engine harness tan lead to clean engine ground Engine must slow to approximately
2500 RPM4Stop the engine If engine speed reduced in Step 3, test the temperature switchRefer to Temperature Switch Test,
Section If engine speed did not reduce in Step 3, continue with this procedure5Separate 5-pin Amphenol connector between
the stator assembly and power pack 6Calibrate ohmmeter on appropriate scaleAlternately attach meter leads between terminal
"C",0", and clean engine ground Meter must show high reading 7Attach ohmmeter leads to terminals rf meter shows 400 40 ohms,