1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 123Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 123

7The engine must be stopped before testing each remaining cylinder8Repeat Steps thru for each ofthe remaining cylinders
Step 3 If meter shows low reading, test the temperature switchRefer to Temperature Switch Test, Section 4 3Install junction
box at the timer base 5-pin Amphenol connectors 4Switch peak-reading voltmeter to "POS" and "50"Attach meter black lead to
clean engine ground and meter red lead to the timer base blackwhite lead, terminal "0" INote Do not run engine with timer
base leads disconnected! All junction box switches must be in the ON position5Install correct test propellerStart engine
in test tank and run at 900 RPM in FORWARD6If power pack is good, meter will show 10 volts If meter shows 10 volts, replace