1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 126Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 126

IGNITION OUTPUT TESTS ill plugs installed and torqued in the cylinder headIf neces- I.AAll cranking output tests must be
in(51 mm) from any metal surface'" To avoid possible shock hazard, do not handle ignition coils or spark tester during cranking
tests3If equipped, install the emergency stop switch clip and lanyard assemblyCrank the engineSpark should jump each tester
gap alternately If tester shows good output on all cylinders, go to STEPRUNNING OUTPUT TEST If tester shows good output on
at least one cylinder, go to STEPSENSOR COIL TEST If tester shows no output, go to STEPSTOP CIRCUIT TESTIt is possible for
the ignition system to have problem but still produce good outputIf the enginepops" or "backfires" during starting, the ignition