1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 132Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 132

STEPSENSOR COIL TESTQUIKSTART MODELS Ground Test 1Disconnect the 5-pin Amphenol connector between the timer base and power
black lead to terminal "E"Alternately attach meter red lead to terminals "A", "B", and "C" 3Crank engine and observe meter
at each connection If meter shows 1.5 volt or higher, go to Step If meter shows less than 1.5 volt, check condition of wiring
and connectors If wiring and connector condition is good, go to Ohmmeter Test 4Connect the "0" terminals in the separated
timer base connector using jumper wireConnect the "E" terminals in the separated timer base connector using jumper wire 5Attach
the voltmeter black lead to clean engine groundAttach meter red lead alternately to terminals" A", "B", and "C"6Crank engine