1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 137Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 137

STEPRUNNING OUTPUT TEST 1Twist and remove all primary leads from ignition coils1231 2Use clockwise twist to install on ignition
1231 5Connect voltmeter red lead to No1 terminal extenderConnect meter black lead to clean engine ground 6Start engine and
run under load at RPM where ignition problem exists Meter must show 220 volts or higher7Repeat Steps and for remaining cylinders
If one or more cylinders show low output, go to STEPCHARGE COIL TEST If one or more cylinders show no output, go to STEPSENSOR