1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 151Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 151

Inl 9Using tool as drawn on Page 4-8, or equivalent, push crankcase taper pin toward intake manifold surfaceDo not use any
rod, and piston by cylinder numberMark them No.1 thru No.3 starting at the flywheel endf131 14Using OMC Torquing Socket,
PIN 331638, loosen in stages the rod cap retaining screwsDO NOT remove the screws1141 15Using one hand to support the piston,
remove the rod cap screws with your other handRemove the pistonDo not allow rod to contact inside edge of piston or cylinder
wallReattach each rod cap to its rod as soon as the piston is removedEach cap is unique and can only be installed on its