1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 154Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 154

Inspection 1Before any inspection process can begin, all internal components must be clean and free of excess oil 2Make visual
each cylinder bore for an out-of-round, oversize, or tapered condition Be sure the gauge or micrometer is perfectly square
in the bore when measuring 'sl 6Measure each cylinder in at least two areas as shownEach The cylinder must not be out-of-round
by more than 0.003 in (0,08 mm) area should be measured twiceThe difference between the two measurements in each area is
the cylinder out-of-round dimension The dimensional difference between the two areas is cylinder taper The cylinder taper
must not exceed 0.002 in(0,05 mm) 1sl 8The difference between your measurements and standard bore dimension is cylinder oversizeRefer
to Engine Specifications, Section 1, for dimensions The cylinder must not be oversize by more than 0.003 in(0,08 mm)If any