1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 158Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 158

10 11 If removed, install new lower main bearingWhen pressing on the bearing, support the crankshaft between the two lower
main bearing O-ring with OMC Triple-Guard grease f131 16Install main bearing assembly and O-ring Seal must face 1141 17Remove
rod caps and keep them identified by cylinder numberLubricate the crankpin bearing assemblies and connecting rods with Johnson
or Evinrude Outboard LubricantPlace one half of the bearing assemblies in each connecting rod Gently lower the crankshaft
and main bearing assembly Into place Align upper O-ring in its groove Align main bearings with locating pins Install and