1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 180Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 180

f81 3Remove the screws from the inner exhaust housing to the adapterRemove the adapter from the inner exhaust housingRemove
on the adapterObserve orientation mark for correct alignment and position the water tube to align it with the water pumpInstall
the screws and tighten to torque of 60-84 inIbs(7-9 Nm) r,v 3Clean the adapter and exhaust housing mating surfaces with OMC
Cleaning SolventApply OMC Gel-Seal" to the exhaust housing flangeAssemble the exhaust housing to the adapterInstall the screws
and tighten to torque of 60-84 inIbs(7-9 Nm)4Place the lower mounts in the exhaust housing i Install the lower mount coversTighten
the screws to a _ torque of 60-84 inIbs(7-9 Nm)5Check the condition of the shift rod seal and replace it if necessary Place
exhaust housing assembly in proper position on swivel bracket 14 7Install the flat washer onto the long screwApply OMC Nut