1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 181Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 181

8Tighten all three screws to following torques: Two side screws15-17 ftIbs(20-23 Nm) Center screw28-33 ftIbs(38-45 Nm) washersInstall
the steering arm, install the two screwsTighten 11While holding the steering handle assembly in place the screws to torque
of 28-30 ftIbs(38-41 Nm)Install and tighten locknutsReplace the locknuts if definite resistance to tightening is not felt12Route
the steering handle throttle cable and stop button wires through the grommet in the lower engine coverPosition the lower
engine cover on the exhaust housingInstall the screws, with washers, through the support bracket into the adapterTighten