1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 185Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 185

1211 6Lubricate and place the bushings in the swivel bracket1221 7Place the swivel bracket in the stern bracketsLubricate
stern 9Manual Tilt ModelsPlace one tilt bolt washer on the 1231 10Install the shock absorber upper pin through the swivel
bracket and shock absorber rod endInstall the spring clip on the pin12411251 11Insert the steering friction washer in the
swivel bracketInsert the steering friction bushing in the swivel bracket with the "M" stamp to the front12Install the bushing
retaining screw in the top rear of the swivel bracketTurn the screw in until it is in the slot of the bushingContinue turning
until it contacts the bushingBack out the screw one-quarter turnThis screw is patch lock screw and should be replaced if
the patch no longer adds friction1261 13Install the top and bottom seals in the swivel bracket with the lips facing out1271