1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 197Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 197

20 7Put tie straps on braided tube ends and attach stop switch assembly to outer handle 1211 8Install the idle adjustment
the stop button leads and throttle cable through the lower engine cover grommet2Apply OMC Triple-Guard grease to the two
steering handle bushingsPlace the bushings into the steering bracketAttach the steering handle to the bracket ill locking
The steering handle nut must have nylon patch for Replace the nut it if has lost is locking featureTighten the nut so the
steering handle can be pivoted and maintain any position3Secure the stop button lead to the powerhead 4Using OMC Pin Insert
Tool, PIN 322697, and isopropyl alcohol, insert the wire into 5-pin Amphenol connector5Thread the throttle cable bracket,
jam nut, and pivot connector on the throttle cable6Refer to Synchronization and Linkage Adjustments, Section 1, to adjust