1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 204Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 204

Water Pump Servicing If the gearcase has been in service for any length of time, it is good policy to install water pump
not pump water3Place the a-ring in groove in the impeller housing [] 4Lightly coat the exterior of the impeller cup with
OMC Gasket Sealing CompoundInstall the cup in the impeller housing The liner locks in place in the housing with an index
tab CD 5Lightly coat the liner with oilWith counterclockwise rotation, install the impeller into the liner with slot for
impeller cam facing out6Run thin bead of OMC Adhesive sealant in the seal groove, and install the special-shaped a-ring seal
7Install the water tube grommet with the inside chamfered edge facing upSeat the grommet in the impeller housingSecure the
water tube bracket to the impeller housing 8Apply thin bead of OMCAdhesive Msealantto groove of the impeller housing grommetPlace