1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 209Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 209

9Remove the pinion and driveshaft from the gearcase as follows: Pull up on the shift rod to engage FORWARD gear position
the slotAlternately tighten the two vertical screws against the backing plate inserted between the puller and the gearcase
until the driveshaft pops loose from the pinion ITIl Remove the driveshaft with the driveshaft bearing housand thrust ingand
shim(s) (h)thrust washer bearing from the gearcaseReach inside the gearcase and remove the pinionIt may be necessary to pull
up on the shift rod to gain enough clearance to remove the pinion 10Push down on the shift rod and unthread the shift rod
from the detent leverRemove the four screws, shift rod, and cover assembly from the gearcaseDiscard the cover gasketRemove