1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 212Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 212

Propeller Shaft Bearing Housing Service 127 1Remove both seals using OMCPulier Bridge, PIN 432127, and OMC Large Puller Jaws,
behind bearing3Discard the bearing housing O-ringClean housing and bearings in solvent and dry thoroughlyIf bearings were
not replaced, rotate needles with your fingers to check for freedom of movementInspect O-ring groove and sand off any sharp
edges that would cut O-ring and prevent its sealing4Thoroughly clean the four bearing housing retaining screws in solventDiscard