1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 213Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 213

using OMC Bearing Installer, PI 326562Press against the lettered side of the bearing to prevent damage to the bearings when
if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged 1351 1Remove the
two driveshaft bearing housing seals using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131 Discard the
seals 1361 2Remove the O-ring from the bearing housing and discard 3Clean the bearing housing in solvent to remove sealer
from the seal bore and the O-ring groove 13211331 4Install new seals back to back in the bearing housing using OMC Seal Installer,
PIN 326545Apply OMC Gasket Sealing Compound to the metal casings of the seals before installingInstall the inner seal with
flush lip facing toward the bearing housing, then the outer seal with extended lip facing away from the bearing housingApply