1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 214Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 214

Driveshaft Shimming Using Tool, PIN 393 185 The driveshaft pinion is precisely meshed with the forward and reverse gears
tapers prior to assembly1381 1Install the pinion onto the driveshaftTighten the pinion nut to 40-45 ftIbs(54-60 Nm) 2Assemble
the driveshaft bearing housingthrust washerand thrust bearing onto the driveshaftUse OMC Driveshaft Seal Protector, PI 312403,
whenever installing or removing the bearing housing COA3594 3Select the correct gauge and collar: use OMC Gauge, PIN 328366,
and OMC Collar, PI 328363 4Slide the collar onto the driveshaft with large end in contact with the bearing housing 13911401
5Insert the assembled driveshaft into the tool base and tighten preload screw against the driveshaft until groove on the