1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 215Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 215

8Check the squareness of the bearing housing mounting surface by holding the gauge bar against the pinion while rotating
the pinion or the driveshaft, as necessary, and repeat the check if variance exceeds 0.002 in(0,050 mm)10Subtract the average
clearance measurement you obtained in Step from 0.020 in(0,508 mm) to determine the correct shim thickness requiredSelect
the fewest number of shims to achieve the correct thickness11Remove the driveshaft from the tool baseRemove the collar and
bearing housing from the driveshaft, and add the required amount of shimsUse extreme care when removing bearing housing to
avoid damaging the sealsUse OMC Driveshaft Seal Protector, PIN 31240312Check shimming by reassembling the driveshaft with