1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 228Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 228

6Examine the pulley and the starter housingLook for sharp edges and rough surfaces that could fray the starter ropeFile and
of the rewind springSecure the crank and pin assembly to the starter winder base with the crank retainer screw 4Rotate the
crank and pin assembly in the direction shown on the toolWind the spring into the starter winder base until end of spring
contacts the starter winder base 5Remove the crank retainer screw and the crank and pin assembly from the starter winder
baseRemove the starter winder base from the vise 6Install the rewind spring into the starter housingLocate the outer loop
of the rewind spring on the pin in the starter housingPress down through the holes in the spring winder base to transfer
the rewind spring into the starter housing COA1364 7Apply OMC Triple-Guard Grease or Lubriplate 777 to the pulley bushing