1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 229Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 229

f171 8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the slot of the pulley
Q) and washer into the starter housingTighten screw to torque of 10-12 ftIbs(14-16 Nm)Spray threads of starter pawl plate
retaining screw that protrude through the starter housing and threads of the nut with OMC Locquic PrimerApply OMC Screw Lock
to the threads of the nutInstall and tighten the nut securely14Using the shoulder screw, install the rope guide to the starter
housingTighten the shoulder screw securely COA1375 1221 15.If removed, install the starter handle bracket to the starter
housingBe sure to place the washers CD between the rubber mounts of the starter handle bracket and the starter housingTighten
the shoulder screws securely16If necessary, tie knot to one end of the starter ropeWith the starter housing upside down on
bench, wind the pulley counterclockwise until the rewind spring is tightBack off the rewind spring until the rope cavity
of the pulley is aligned with the rope guideThread the starter rope through the pulley, rope guide, and outlet in the starter