1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 230Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 230

1231 17Apply OMC Triple-Guard Grease or Lubriplate 777 to the handle end of the starter ropeUsing OMC Starter Rope Threading
assembly onto the motorPlace the lifting ring on the rear screw mounting bossInstall the five starter housing retaining screwsBe
sure to place washers between the starter housing rubber mounts and the motorTighten the three starter housing screws to
torque of 10-12 ftIbs(14-16 Nm)Tighten the two starter handle bracket screws to torque of 60-84 inIbs(7-9 Nm)2If equipped
with starter interlock, apply OMC Triple-Guard Grease or Lubriplate 777 to the starter lockout slide area of the starter
housingPlace the starter lockout slide in the channel of the starter housingLoosely secure the starter lockout cable to the
starter housing with cable clamp and screw Shift the motor to NEUTRAL positionAdjust starter lockout cable so that starter