1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 280Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 280

Power Supply Troubleshooting Before beginning this procedure: Charge battery and connect battery cables Turn key switch
V2 If no voltage at V1check red wire between starter solenoid terminal and relay bracketIf red wire is OK, check black wire
between relay bracket and engine ground If voltage at V1, go to Step 55Connect voltmeter black lead to clean engine ground,
and voltmeter red lead to V3 (bluewhite)6Push control box UP trim button If no voltage at V3check control box trim switch
and wiring, and go to Step If voltage at V3, go to Step 7 [!] 7Push lower motor cover UP trim button If no voltage at V3check