1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 281Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 281

7(continued) If no voltage at V3, disconnect bluewhite tilt limit switch bullet and t? by-pass tilt limit switchRepeat Step
wire between relay bracket and engine ground If voltage at V5, go to Step 14f1l 14Connect voltmeter black lead to clean engine
ground, and voltmeter red lead to V7 (greenwhite) [!] 15Push control box DOWN trim button If no voltage at V7, check control
box trim switch and wiring, and to to Step 16 If voltage at V7, go to Step 16 [!] 16Push lower motor cover DOWN trim button
If no voltage at V7, check for voltage at greenwhite bullet connector out of lower motor cover trim switchCheck for voltage
at redwhite connector that supplies lower motor cover switch If voltage at V7, go to Step 1717Reinstall DOWN relayPush blades
only halfway into bracket in DOWN (green) end of bracket [!] [3] 18Push DOWN trim button and check for voltage at va on relay
blade (M terminal of relay) If no voltage at va, go to Relay Ohmmeter Test If voltage at va, go to Step 1919Disconnect trim