1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 284Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 284

Trim Gauge Troubleshooting 1Turn key switch ON and use voltmeter to check for voltage between trim gauge terminals "I" and
voltage, check condition of key switch and motor harness 20-amp fuse4Turn key switch OFF fN'=J To avoid immediate meter damage,
never apply an ohmmeter to an electrical circuit where voltage is present Remove trim harness leads from gauge terminals
"S" and "G"Calibrate an ohmmeter on appropriate scale and connect between the leadsWith the engine fully DOWN, meter must
show approximately 88 ohmsWith the engine fully UP, meter must show approximately ohm If your results agree, replace the