1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 286Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 286

Pressure Leakdown Test Po.wer ServiceKit, PIN 434524, allows external verrflcatlon of trlmtllt operation and component condition
rods will not retract without the gearcase pushing them3Loosen the manual release valve one turn ill vent 4Jog the trim motor
UP, then DOWN, then UP again to any pressure at the manual release valve before removing itTo avoid personal injury, always
wear eye protection when servicing the hydraulic unitSince there might be significant residual pressure behind some components,
cover each component with shop cloth as you remove itfil 5Slowly, remove the manual release valveHandle the valve very carefullyDo
not scratch, bend, or dent the split ringsr;] 6Clean and inspect the manual release valve and its port in the manifoldSplit
rings on the valve are not available separatelyIf split rings are damaged, replace manual release valve assembly Safety Related