1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 287Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 287

f51 7.lnstall pressure gauge and adapter "A" to check problems in the UP circuitTighten gauge and adapter lightly to 5-10
and 8, install pressure gauge and adapter liB" to check problems in the DOWN circuit12Starting with the tilt cylinder fully
extended, run the unit DOWN The gauge should show 0-200 PSI (0-1379 kPa) as the tilt cylinder is retracting The gauge should
show (5516 kPa) as the unit stallsapproximately 800 PSI 27343 Release the switch and watch for pressure dropThe stall pressure
reading must not drop by more than 200 PSI (1379 kPa) after the motor stops13If your test results vary from those in Step
12, problem in the DOWN circuit is indicatedRefer to Hydraulics Troubleshooting, this section "'" 14After tests are complete,
jog the unit UP, then DOWN, then UP again to vent any high pressure before removing the gauge I.A 15Install the manual release