1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 291Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 291

Disassembly Thoroughly, clean the unit before disassembling itScrub all outside surfaces with stiff brush and hot, soapy
components may cause flakes of paint to enter the hydraulic passages during assemblyTape the trim and tilt piston rods before
painting rv ring usingthe manualring pliersRemove the manualretaining 1Screw release valve in Remove the retaining release
valvef21 2Inspect O-ring and two plastic split rings on the manual release valve for nicks and cutsInspect tip of valve for
damageThe two plastic split rings are not available separatelyIf rings are damaged, replace the manual release valve2 rJl