1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 294Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 294

19 22882 dPry the O-ring out of the end capDiscard the O-ring eRemove the outside O-ring Discard the O-ring Clean the end
end cap onto the rodiRemove any lubricant from the threads on the rod, prime with OMC Locquic Primer, and let drySlide the
piston assembly onto the rod Place new rod O-ring over the threadsjClean any thread locking material from the threads on
the inside of the nutSpray threads of nut with OMC Locquic Primer, and let dryApply small amount of OMC Nut Lock to threads
of nutSlide the washer over the threads and install the nuttorque to 58-87 ftIbs(79-118 Nm)kInspect both rod end bushings