1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 313Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 313

t=I the UP circuit 8Install pressure gauge and adapter "A" to check problems in fN=J Tighten gauge and adapter lightly to
faults t=I adapter liB" to check problems in the DOWN circuit 12Following Steps through 9, install pressure gauge and 13With
all cylinders completely extended, begin running the unit DOWN The gauge should show approximately 800 PSI (5516 kPa) as
the cylinders are retracting The gauge should show approximately 900 PSI (6206 kPa) as the unit stalls The stall pressure
reading must not drop by more than 200 PSI (1379 kPa) after the motor stops14If you test resu Its vary from those inStep
13, problem in the DOWN circuit is indicatedRefer to Page 9-45 for list of possible faults rv andAfter tests 45-55complete,(5-6
Nm)Install retaining ring15are install the manual release valve L!J torque to inIbsill '" Manual release valve must be properly