1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 316Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 316

Power TrimTilt Servicing Removal 1Mark angle adjusting rod location and remove rod2Lift engine manually and engage tilttrail
the internal pressures of the power trimtilt unit before disassemblingUsing battery, operate the unit until the trim and
tilt cylinders are completely downReverse the connections on the battery and momentarily operate the unit I.A There may be
high pressure behind some check valves and hydraulic linesTo prevent possible eye injury, when removing lines and check valves,
be sure to keep clean, "lint free" shop cloth covering them until the pressure is releasedUse eye protection ill sive temperature
can cause high pressure leaks or failure of partsAlways use "lint free" shop cloth when handling power trim and tilt componentsIf
painting the unit is required, paint the unit after it is completely assembledPainting of individual components may cause