1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 317Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 317

o C0A2417 f511Be sure the manual release valve is screwed in all the wayRemove the retaining ring using OMC Retaining Ring
at each endInspect all four -rings and replace -rings if necessarypin out of the unitRemove the tilt cylinderVery carefully
and slowly, cycle the cylinder once or twice while aiming the oil feed ports down toward the oil drain panRemove the two
nylon bushings from the cylinderf12l 8Currently, there, are two styles of tilt cylindersIdentify which one you have prior
to making any repairs or selecting replacement partsThe cylinder shown at the top of the figure is referred to as the Showa
brand cylinderThe cylinder shown at the bottom of the figure is referred to as the Presto lite brand cylinderWhen replacing
an entire cylinder, either one can be usedWhen replacing individual parts including the band and band nut, only those specified