1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 318Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 318

COA2425 f131 9When servicing either cylinder, mount the bottom part of the cylinder in soft-jaw viseIf equipped, remove the
for excessive scoring14Service the Showa piston and rod assembly as follows: Using OMC Hydraulic Cylinder Rod Holder, PIN
983213, clamp the rod tightly in viseRemove the nut and washer from the piston end of the rodthe four valve assemblies which
consist of springplungerand check ball Three of the four springs are one length, and the fourth spring is another lengthOn
reassembly, these springs can be put in any positionInspect the outer O-ring from the piston and the O-ring that was around
the rod Replace the O-rings if necessaryReassemble the piston by placing one ball, one plunger, and one spring in each of
the four holes in the piston Place the outside O-ring on the piston 1191 bSlide the tilt piston off the rodRemove the outer