1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 319Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 319

COA2433 1201 cUsing sharp screwdriver, pry the scraper out of the end capDiscard the scraperdPry the O-ri ng out of the end
threads on the tilt rodUsing OMC Tilt Cylinder Seal Protector, PI 326005, slide the end cap onto the rodCOA2435 1261 iClean
any Locktite material from the threads on the inside of the nutSpray threads with OMC Locquic Primer and let dryApply small
amount of OMC Nut Lock to the threads of the nutSlide the washer over the threadsInstall the nutTighten the nutto torque
of 58-87 ftIbs(79-118 Nm)Iffor some reason the rod has been unscrewed from the eyelet, clean the threads of the rod at that
end and the threads inside the eyelet with OMC Locquic PrimerApply small amount of OMC Nut Lock to the threads, thread the
rod into the eyelet, and torque both the nut and the rod into the eyelet at the same time15Service the Presto lite piston