1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 320Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 320

C0A2439 COA2442 bQuickly clamp the piston tightly in soft-jaw viseUsing breaker bar or similar tool through the eyelet, unscrew
capThe square back-up ring goes above the O-ringfUse heat lamp or hot water to warm new scraperInstall the scraper in the
end cap with the lip facing upgSecure the eyelet end of the rod in soft-jaw viseUsing OMC Tilt Cylinder Seal Protector, PI
326005, slide the end cap onto the rod in the direction shownPlace new outside O-ring on the end caphSpray the threads of
the rod and the internal threads of the piston with OMC Locquic PrimerIn soft-jaw vise, secure the piston firmly with the
smaller valve holes facing UPApply one or two drops of OMC Nut Lock to the threads of the rodThread the rod into the pistonTighten