1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 327Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 327

2Oil and install both trim caps on the trim rods, as shownf313Reinstall the manifold in the holding fixtureOil and install
you are finished r&16Oil and install both trim end caps in the manifoldThread them in flush with the manifold by handUsing
OMC Trim Cylinder End Cap Remover, PIN 324958, and torque wrench, tighten the end caps to torque of 55-60 ftIbs(75-81 Nm)rJl7Install
the two identical short check valves in the front of the manifoldTighten the valves to torque of 50-60 inIbs(5,5-7,0 Nm),
using drag link socket and torque wrench1sl8Install the longer trimtilt separation valve in the port lower side of the manifoldTighten
the valve to torque of 50-60 inIbs(5,5-7,0 Nm)Oil and install the pump control piston in the position shownInstall spring
on each end of the piston and make sure both springs stay in position correctly when inserting the valve in the manifoldr:tOl10Oil