1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 329Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 329

COA2503 '18l20Inspect the rubber keeper on the pump drive coupling (N)The rubber keeper provides cushion between the motor
fluid, fill the cavity where the pump is mounted, up to the top of the filterr:;:;J 24Using screwdriver, rotate the pump
coupling several turns clockwise and then several turns counterclockwise until no more air bubbles come out of the pumpIt
is very important that the pump area be filled with oil and purged of air because the pump could be damaged if installed
dryr:;:;J 25Clean the bottom of the motor where it engages the manifoldInstall new O-ring on the motorPosition the motor
on the manifold and install the three screws and lock washersTighten the screws securely 124126Mount the bottom flat end
of the tilt cylinder in soft-jaw viseSlide the tilt rod and end cap up far enough to be able to install the universal spanner