1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 330Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 330

wrench installed 90 to the special tool, tighten the end cap to torque of 18-21 ftIbs(24-28 Nm)Tighten band nut securelyDo
lines to torque of 14-18 ftIbs(19-24 Nm) 252627Thread the end cap into the cylinderUsing torque 27 28Position the manifold
as shownInstall the tilt cylinder pin281 29Rotate the unit into its normal operating positionUsing the correct fluid, fill
the oil reservoir up to the fill plugInstall and tighten the fill plugDo not torque the fill plug at this time 30Run the
motor, then recheck the oil levelCycle the unit several times and check the oil level when the trim and tilt cylinders are