1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 332Get this manual

1995 Johnson/Evinrude Outboards 50 thru 70 3-cylinder Service Manual, Page 332

Trim Sending Unit Adjustment It might be necessary to adjust the trim sending unit to coincide with the trim gauge at full
only snug, so the sending unit can be pivoted5Lower the engine all the way down against the angle adjusting rodr:;;l6Observe
the trim gaugeIf the needle does not show center positionadjust the sending unit by pivoting it up or down with screwdriver,
until the gauge shows the needle in the center position7Raise the engine and tighten the sending unit screwsLower the engine