1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 28Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 28

Warning Horn A warning horn is built into the OMC prewired remote control or is part of the OMC accessory wiring harnessThe
as self-testIf not proceed as follows1Disconnect bullet connector at temperature switch 2Connect engine harness half of bullet
connector to clean engine ground 3With the key switch in the ON position, the horn should soundIf the horn does not sound,
but other electrical components function correctly, the horn or wiring may be damagedRepair or replace as required 4Reconnect
temperature switch bullet connector 5Using jumper wire, attach oil pressure sender tan lead to clean engine ground 6With