1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 36Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 36

Synchronization and Linkage Adjustments Tiller Models INote You must perform this step-by-step procedure exactly as written
and washer retaining the throttle cable bracket 5Pull on throttle cable casing to move the throttle cam away from the cam
follower roller6Connect your shop tachometer pickup on the ignition coil's primary lead, and set its selector switch on 2-cycleStart
the engine and verify idle speed in FORWARD gear7Stop the engineAdjust the idle speed screw to achieve 850 50 RPM in FORWARD
gear8Start the engine and verify your adjustmentRepeat Step 7, if necessary9Stop the engineRotate twist-grip to full SLOW
positionPull on throttle cable casing to remove throttle cable backlashAdjust the throttle cable bracket to provide 132 in(0,8
mm) gap between the throttle cam and cam follower roller when the throttle cable bracket is installed10Install the throttle