1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 40Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 40

Remote Control Cable InstallationEngine To prevent accidental starting of engine, verify that battery cables are disconnected
before continuing with installation m 5Install shift link on shift lever and retain with spring clip[]] 6Remove screw retaining
cable anchor retainerRemove retainerThrottle Cable 1Remove the rubber grommet from front of lower engine coverRemove cable
retainerApply liberal amount of 0fv'IC TripleGuard grease to both anchor block pockets2Extend throttle cable and lubricate
with 0fv'IC Triple-Guard grease3Move the remote control handle to NEUTRALVerify that the fast idle lever is down in the RUN
position m fA supplied with engineguide to throttle lever pin using 4Attach cable casing retainer 5Pull firmly on throttle
cable to remove backlashInstall trunnion nut in anchor pocketAdjust trunnion nut to provide 132 in(0,8 mm) gap between the
throttle cam and cam follower roller 6Check cable adjustment: If throttle cable adjustment is too loose, idle speed might