1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 62Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 62

WAssembly INote Before proceeding, be sure that all parts are perfectly cleanBe sure that all replacement parts match original
and function[[] Turn carburetor body upside down and hold so gasket surface is horizontalThe weight of the float will close
the float valve needleRest CIVIC Float Gauge, PIN 324891, on gasket surface and slide gauge up, next to floatTop of float
should be between notches on gauge [[] Use notch that is indicated "9.915 HP Be certain gauge is not holding down the float
If float level is not between the notches of gauge, lightly bend metal float arm to adjust levelBe careful not to force float
needle valve into seat7Check for correct float drop dimensionThis dimension affects the full opening of the inlet needle
and is critical to correct operation of the carburetorWith carburetor body in normal running position, the float must drop
open to dimension shownTo adjust, bend tab on float arm where tab contacts float seat Base of carburetor body Bend float