1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 74Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 74

Flywheel Servicing Notelln order to produce the voltage necessary to run an ignition system, the flywheel magnets must be
crankshaft 4Assemble the following components from OMC Universal Puller Set, PIN 378103: Body, PIN 307636 Pressing Screw,
PIN 307637 Handle, PIN 307638 Screws, PIN 307641 Washers, PIN 307639 5Install the puller on flywheel with body flat side
upSeat the shoulder screws completelyHold puller by its handle, and tighten pressing screw until flywheel releases6Remove
the flywheelInstallation 1Install the flywheel key: [[] Install the key with its outer edge parallel to centerline of crankshaft
and single upset mark facing down2Clean the crankshaft and flywheel tapers with OMC Cleaning Solvent and let dryThese surfaces
must be clean and dry to allow proper locking of the tapers3Align the flywheel keyway and install flywheelCoat the threads