1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 92Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 92

STEPPOWER COIL TEST Ground Test 1Disconnect 4-pin Packard connector between stator and ignition module2Set peak-reading voltmeter
stator 3Crank engine and observe meter: If meter shows 100 volts or higher, go to STEPCHARGE COIL TEST If meter shows less
than 100 volts, check condition of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter
Test All ohmmeter tests must be performed with engine NOT running 1Calibrate ohmmeter on appropriate scale2Connect meter
between the two orange stator leadsMeter must show: Rope Start Electric Start 84 Ohms 57 Ohms 3To test for grounded condition,
connect ohmmeter black lead to clean engine groundAlternately connect ohmmeter red lead between the two orange stator leads: