1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 93Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 93

DR5685A STEPCHARGE COIL TEST Ground Test 1Disconnect 4-pin Packard connector between stator and ignition module2Set peak-reading
lead If meter shows 300 volts or higher, go to STEPIGNITION MODULE TEST If meter shows less than 300 volts, check condition
of wiring and connectors If wiring and connector condition is good, go to Ohmmeter TestOhmmeter Test 3Crank engine and observe
meter: INote All ohmmeter tests must be performed with engine NOT running 1Calibrate ohmmeter on appropriate scale2Connect
meter between the two brown stator leadsMeter must show: Rope Start Electric Start 1120 110 Ohms 800 80 Ohms 3To test for
grounded condition, connect ohmmeter black lead to clean engine groundAlternately connect ohmmeter red lead between the two