1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 95Get this manual

1995 Johnson/Evinrude Outboards 9.9, 15 four-stroke Service Manual, Page 95

1 DR5688 STEPRUNNING OUTPUT TEST 1Twist and remove primary lead from ignition coil 2Use clockwise twist to install Stevens
5Connect meter red lead to terminal extenderConnect meter black lead to clean engine ground 6Start engine and run under load
at RPM where ign ition problem exists: Meter must show 240 volts or higher If test shows low output, go to STEPCHARGE COIL
TEST If test shows no output, go to STEPIGNITION MODULE TEST7Remove terminal extenderInstall ignition coil primary lead 4-Cycleeng